Oregon DOT

This PGSuper configuration is hosted at PGSuper.com and implements beam shapes and LRFD settings used by the Oregon Department of Transporation (ODOT).

Implemented Girder Shapes

• AASHTO Bulb-I (BI) and Bulb-T (BT) Beams as implemented by ODOT

Assumptions and Limitations

• Strict AASHTO LRFD interpretation (most recent version implemented in PGSuper). Does not contain agency-specific provisions or interpretations.
• Girder lifting and hauling are considered in specification checking, but not used by the automated design algorithm

Quality Rating:DRAFT

Click here for a description of quality ratings.

PGSuper Set Up Instructions

This configuration is hosted at PGSuper.com. Refer to this tutorial for detailed set up instructions.

References

• Oregon Bridge Section Home Page
• Oregon Beam Section Plan Sheets
• Oregon Bridge Design and Drafting Manual
• Oregon Beam Details
• AASHTO LRFD Bridge Design Specifications,1998-present
• PCI Bridge Manual, Appendix B, AASHTO/PCI Bridge Products
  

Revision History

• July 29, 2010 - Initial Release

Developer

• BridgeSight Staff

Disclaimer

IN NO EVENT WILL WE BE LIABLE TO YOU FOR ANY DAMAGES, INCLUDING ANY LOST PROFITS, LOST SAVINGS, OR OTHER INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR THE INABILITY TO USE THE SOFTWARE (EVEN IF WE OR AN AUTHORIZED DEALER OR DISTRIBUTOR HAS BEEN ADVISED OF THE POSSIBILITY OF THESE DAMAGES, OR FOR ANY CLAIM BY ANY OTHER PARTY.

SOME STATES DO NOT ALLOW THE LIMITATION OR EXCLUSION OF LIABILITY FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.